Release Notes

Description: Creation of a chassis template from a reference M1000e chassis which has Firmware versions 6.10 or later fails if
SMBv1 is disabled in the appliance. [129049]
Resolution: Enable SMBv1 in the appliance using Application Settings > Console preferences > SMB settings to create
chassis templates from M1000e chassis with firmware versions 6.10 or later.
Issue 21
Description: Template Deployment with iDRAC Management IP option "Set static IP for each device" fails with error message
"connection lost" with IPV6 IP (Legacy(3.1)). It works with IPV4.
Issue 22
Description: Template Deployment with iDRAC Management IP option "Set as DHCP" fails, and the task has to be tracked from
iDRAC for final status.
Others
Issue 1
Description: With OIDC provider PingFederate, it is observed that all the OpenID client policies associated with the
OpenManage Enterprise Client IDs are reset to the policy marked as 'Default' when the appliance console gets re-registered
with the OIDC provider. Re-registration of the appliance console with OIDC provider happens in the event of an appliance
upgrade, change in network configuration, or change in SSL certificate. [193717]
Resolution: This is an issue with the OIDC provider, hence, the administrator must reconfigure all the OpenManage Enterprise
Client IDs on the OIDC provider site to avoid any security concerns.
Issue 2
Description: On VMware vSphere, changing the appliance's time to an earlier time than the system time fails if the periodic
time synchronization in the VM is enabled. [198702]
Resolution: To set the appliance's time to an earlier time than the system time, disable the periodic time synchronization in the
VM, by launching the vSphere Client, go to Edit Settings > VM Options > VMware Tools > Synchronize Time with Host
and deselect the checkbox Synchronize time periodically.
Issue 3
Description: The traps forwarded from one OpenManage Enterprise console to another OpenManage Enterprise console are
received as Miscellaneous category alerts with message "unknown trap received...," if the Trap Forwarding Format is set as
"Original Format" in the former console. [188953]
Issue 4
Description: An error 'Error getting identity pool information (CGEN1006)' is displayed when sorting is done on an identity
pool's Usage page fields. Also, the identity pool's Usage page turn blank when View By filter is applied. [200451]
Resolution: Return to the identity pool's Usage page after navigating to another page.
Issue 5
Description: Post upgrade, enabling SNMPv3 on the Application Settings > Incoming Alerts page displays an error
'modules.newSettings.alerts.snmpGeterror (CGEN6008)'. [202270]
Issue 6
Description: Post upgrade, a delay is observed in the integration and authentication of large Microsoft Active Directory (AD)
groups. [201800]
Issue 7
Description: If an email alert policy is created to be executed on a specific day(s) without reselecting the Time Interval, then
the appliance might trigger the emails at incorrect time interval. [198784]
Resolution: When scheduling email alert policies, reselect the Time Interval along with the days. Or, create non-interval policies
without Days' selection.
Issue 8
Description: If SNMPv3 destination(s) is/are already added as alert forwarding destination(s) in the appliance, then in order
to add and apply a new alert forwarding destination address, the appliance prompts a re-enter of all the previously entered
SNMPv3 Authentication and Privacy passphrases before proceeding. [190690]
Issue 9
12