Users Guide

c. In the Export All wizard, select any of the following file formats: HTML, CSV, and PDF.
d. Click Finish. A job is created, and the data is exported to the selected location.
Create a device discovery job
The following steps describes how to initiate a device discovery job in OpenManage Enterprise to discover the devices in your
data center using the Create Discovery Job wizard.
NOTE: To perform any tasks on OpenManage Enterprise, you must have necessary user privileges. See Role and scope-
based access control in OpenManage Enterprise on page 15.
1. To initiate the Create Discovery Job you can do one of the following steps:
● Click Monitor > Discovery > Create.
● Alternatively, from the All Devices page (OpenManage Enterprise > Devices), click the Discovery drop-down menu
and click Discover Devices.
2. In the Create Discovery Job dialog box, a default job name is populated. To change it, enter the discovery job name.
By default, the dialog box enables you to define properties of similar devices at a time.
● To include more devices or ranges to the current discovery job, click Add. Another set of the following fields is displayed
where you can specify the device properties: Type, IP/Hostname/Range, and Settings.
WARNING: A maximum of 8,000 devices can be managed by OpenManage Enterprise. Hence, do not
specify large networks that have devices more than the maximum number of devices supported by
OpenManage Enterprise. It may cause the system to abruptly stop responding.
NOTE: When discovering a large number of devices, avoid creating multiple discovery jobs using individual IP address
and instead use IP range of the devices.
● To discover devices by importing ranges from the .csv file. See Specify multiple devices by importing data from the .csv
file on page 46.
● To exclude certain devices, remove devices from being excluded, or to view the list of devices excluded from being
discovered, see Globally excluding device(s) from discovery results.
3. From the Device Type drop-down menu, to discover:
● A server, select SERVER. See Specifying discovery mode for creating a server discovery job.
● A chassis, select CHASSIS. See Specifying discovery mode for creating a chassis discovery job.
● A Dell EMC storage device, or network switch, select DELL STORAGE, or NETWORKING SWITCH. See Specifying
discovery mode for creating a storage, Dell storage, and network switch discovery job.
● To discover devices by using multiple protocols, select MULTIPLE. See Specify discovery mode for creating a MULTIPLE
protocol discovery job on page 51.
4. In the IP/Hostname/Range box, enter the IP address, host name, or the range of IP address to be discovered or included.
For more information about the data you can enter in this field, click the i symbol.
NOTE:
● The range size is limited to 16,385 (0x4001).
● IPv6 and IPv6 CIDR formats too are supported.
5. In the Settings section, enter the username and password of the protocol that is used for discovering the ranges.
6. Click Additional Settings, to select a different protocol, and change the settings.
7. In the Scheduling Discovery Job section, run the job immediately or schedule for a later point of time. See Schedule job
field definitions on page 172.
8. Select Enable trap reception from discovered iDRAC servers and MX7000 chassis to enable the OpenManage
Enterprise receive the incoming traps from the discovered servers and MX7000 chassis.
NOTE:
Enabling this setting will enable alerts on the iDRAC (if disabled), and set an alert destination for the
OpenManage Enterprise server's IP address. If there are specific alerts that need to be enabled, you must configure
these on the iDRAC by enabling the appropriate alert filers and SNMP traps. For more information, see the iDRAC User's
Guide.
9. Select Set Community String for trap destination from Application Settings. This option is available only for the
discovered iDRAC servers and MX7000 chassis.
10. Select the Email when complete check box, and then enter the email address that must receive notification about the
discovery job status. If the email is not configured, the Go to SMTP Settings link is displayed. Click the link, and configure
42
Discovering devices for monitoring or management