Release Notes

Description: The Firmware Update task fails on the MCM member chassis with error message 'Syncing data with passive MM
Task Failed. Completed With Errors'. [169333]
Configuration management
Issue 1
Description: For the MX7000 chassis managed with OpenManage Enterprise - Modular versions 1.31.00 or earlier, the
remediation task (Make Devices Compliant MX7000) fails with an error message — "error while applying Setting: Users|
Directoriesnull|null Required fields are missing (UserName or Password)." [193435]
Resolution: Disabling the "User Directories" section in the compliance template and then initiating the Make Compliant task
successfully completes the remediation task.
Issue 2
Description: If only VLANs are assigned to a target device during profile deployment, then these VLANs are not reclaimed by
the appliance when the profile is unassigned from the device. This behavior is not seen if other identities were assigned along
with VLAN definitions during the profile deployment. [174360]
Issue 3
Description: User Password attributes can't be set on the MX7000 and the Chassis Management Controller Deployment
templates. [200293]
Issue 4
Description: If only VLANs are assigned to a target device during profile deployment, then these VLANs are not reclaimed from
the device when the profile is migrated to a new device. This behavior is not seen if other identities were assigned along with
VLAN definitions during the profile deployment. [174576]
Issue 5
Description: Profile redeployment on FX2, VRTX, and M1000e chassis with edited VLAN configuration (tagged and untagged
values), clears only those VLAN values which were set during the initial deployment of the profile. The other VLAN values on the
ports that were not set during the initial deployment of the profile are not cleared during redeployment. [175692]
Issue 6
Description: Editing a Configuration template that is associated to a baseline which is either linked to a group of devices or a
large number of devices (20 or more) might cause a timeout with error message ' An application request timed out.
Please contact your support representative if the issue persists'. The changes however are saved to
the template in spite of the timeout. [164626]
Issue 7
Description: Same inventory details can be present on two servers post migration, as the 'true' target-specific attributes are
not reclaimed from the 'source' server as part of migration. [160622]
Issue 8
Description: The Reclaim Identities and Profile Migration features are not supported for Emulex OneConnect Cards. [98511]
Issue 9
Description: If the MX7000 chassis is in the 'monitored' state during stateless deployment, the deployment job fails because
the user does not have necessary privileges. Only the server configuration profile is imported. However, this information is not
displayed in the Task Execution section. [108484]
Issue 10
Description: The changed VLAN name and IDs are not updated on the target MX7000 chassis after a stateless deployment
task is run. [105156]
Issue 11
Description: If the IP setting is not configured on the discovered PowerEdge MX740C and PowerEdge MX840C, the Boot to
Network ISO operation is not run during the template deployment. [102887]
Issue 12
Description: After deploying an MX7000 chassis template, you cannot log in to the MX7000 chassis with LDAP credentials.
[107230]
Resolution: Manually update the LDAP Bind password to log in.
11