Users Guide

NOTE: The IP Address Range, Gateway, Primary DNS Server, and Secondary DNS Server must be valid IPv4
addresses.
Actions
Previous Displays the Ethernet tab.
Next Displays the FCoE tab.
Finish Saves the changes and displays the Configuration page.
Cancel Closes the Create Identity Pool wizard without saving the changes.
Create Identity Pool - Fibre channel over Ethernet
You can add the required number of Fibre Channel over Ethernet (FCoE) Initialization Protocol (FIP) MAC addresses to the
identity pool. The World Wide Port Name (WWPN)/World Wide Node Name (WWNN) values are generated from these MAC
addresses.
Include FCoE
Identity
Select the check box to include the FCoE MAC addresses to the identity pool.
FIP MAC Address Enter the starting FCoE Initialization Protocol (FIP) MAC address of the identity pool in one of the
following formats:
● AA:BB:CC:DD:EE:FF
● AA-BB-CC-DD-EE-FF
● AABB.CCDD.EEFF
The maximum length of a MAC address is 50 characters. This option is displayed only if the Include FCoE
Identity check box is selected.
The WWPN/WWNN values are generated from the MAC address.
Number of FCoE
Identities
Select the required number of FCoE identities. The identities can be between 1 and 5000.
Actions
Previous
Displays the iSCSI tab.
Next Displays the Fibre Channel tab.
Finish Saves the changes and displays the Identity Pools page.
Cancel Closes the Create Identity Pool wizard without saving the changes.
Create Identity Pool - Ethernet
In the Ethernet tab, you can add the required number of MAC addresses to the identity pool.
Include ethernet
virtual MAC
addresses
Select the check box to add the virtual MAC addresses to the identity pool.
Starting virtual
MAC Address
Enter the starting virtual MAC address in one of the following formats:
● AA:BB:CC:DD:EE:FF
● AA-BB-CC-DD-EE-FF
Manage device deployment templates 73