Users Guide
e. Select the Enable Certificate Authority (CA) check check box.
4. To discover IO modules, select the Discover IO Modules with chassis check box.
NOTE: Applicable only for the CMC VRTX, M1000e, and FX2 chassis (models FN2210S, FN410T and FN410S). For the
MX7000 chassis, the IO modules are automatically detected.
NOTE: Only the IO Modules with Standalone, PMUX (Programmable MUX), VLT (Virtual Link Trunking) Modes are
discoverable. Full switch and Stacked Modes will not be discovered.
a. Select Use chassis credentials if the M I/O Aggregator user credentials are the same as that of the chassis.
b. Select Use different credentials if the M I/O Aggregator user credentials are different from the chassis credentials
and do the following:
● Enter the User Name and Password.
● Change the default values for Retries, Timeout, and Port if required.
● Select Verify known Host key, to verify the remote host identity.
● Select Use SUDO Option if needed.
5. Click Finish.
6. Complete the tasks in Create a device discovery job on page 107.
Specify discovery mode for creating a Dell storage
discovery job
1. From the Device Type drop-down menu, select DELL STORAGE.
2. When prompted, select:
● PowerVault ME: To discover the storage devices using the HTTPS protocol like the PowerVault ME.
● Others: To discover storage devices which use SNMP protocol.
Based on your selection, the fields change under Settings.
3. Enter the IP address, host name, or IP range in IP/Hostname/Range.
4. Under Settings, depending on your initial selection — enter the User Name and Password for Storage HTTPS or enter the
SNMP version and the community type of the device to be detected.
5. Click Additional Settings to customize the respective discover protocol. See Creating customized device discovery job
template for SNMP devices or see Create customized device discovery job protocol HTTPS storage devices –Additional
settings for discovery protocols on page 116.
6. Complete the tasks in Create a device discovery job on page 107.
Related information
Discovering devices for monitoring or management on page 105
Specify discovery mode for creating a network switch
discovery job
1. From the Device Type drop-down menu, select NETWORK SWITCH.
2. Enter the IP address, host name, or IP range in IP/Hostname/Range.
3. Under Settings enter the SNMP version and the community type of the device to be detected.
4. Click Additional Settings to customize the respective discover protocol. See Creating customized device discovery job
template for SNMP devices
5. Complete the tasks in Create a device discovery job on page 107.
Discovering devices for monitoring or management
115