Release Notes

Resolution: Go to the Jobs page to view the latest and complete list of jobs.

Issue 6

Description: Discovery operation fails by using IPMI commands on the CISCO server if a KG key is used. [78545]

Resolution: KG key is not supported for this device discovery.

Issue 7

Description: When a device is turned off, the console takes a few moments to display the updated health status. [86146]

Resolution: Refresh the browser, or wait for a few moments.

Issue 8

Description: An individual Chassis Management Controller (CMC) health may not be correctly displayed in the device drill-down operation.

[85977]

Resolution: Always consider the CMC rollup health status.

Issue 9

Description: Certain SNMP alerts are undefined for the S4810 networking switch. [85016]

Resolution: N/A

Issue 10

Description: An unknown Error message occasionally displayed in the SNMP alert console. [84894]

Resolution: Ignore or click Dismiss.

Issue 11

Description: In the SNMP alert console, some alerts from OMSA correctly show the Message ID field, while others show N/A. [83579]

Resolution: N/A

Issue 12

Description: Discovery of an HP server by using IPMI command may not reflect the correct rollup health status. [85153]

Resolution: View the lower-level sensor health data.

Issue 13

Description: In the Execution Details section, data must be manually sorted in the table every time after moving to a new page. [81207]

Resolution: Sort information of a single page at a time.

Issue 14

Description: Currently, the health status including PSU and temperature data is not displayed for the storage devices. [99821]

Resolution: N/A

Issue 15

Description: : The rollback features is not supported on the MX7000 chassis. Also, the rollback operation fails on the M1000e, FX2, and

FX2s chassis. [110239]

Resolution: For M1000e, FX2, and FX2s chassis, create and associate a new baseline with the necessary firmware version to roll back.

Issue 16

Description: Currently, the alerts are not received by OpenManage Enterprise if the alerts are associated with the devices' IP address.

However, alerts are successfully received when associated with the device Service Tag. [106369]

Issue 17

Description: Invalid host names are displayed under the Source Name column and are also available for selection in some of the

OpenManage Enterprise tasks. [68214]

Issue 18

Description: In OpenManage Enterprise version 3.1, authentication by one-way and two-way trusts of AD users is not supported.

Issue 19

Description: From the All Devices page, you cannot launch the iDRAC application interface with IPv6 addresses. [102153]

Issue 20

Dell EMC OpenManage Enterprise Version 3.1 Release Notes