Release Notes

Fixes
Issue 1(134624)
Description: If an invalid job_id is provided, the idrac_lifecycle_controller_job_status_info module returns an error message
with the description of the issue.
Issue 2(188267)
Description: No error message is displayed when the target iDRAC with firmware version less than 3.30.30.30 is updated.
Known Issues
Issue 1(154815)
Description: Firmware update may fail if multiple DUPs are uploaded. Local DUPs are stored in a temporary folder created by a
scratch-pad. The capacity of this folder is only 300 MB.
Resolution: Ensure that the combined size of all of the DUPs is less than 300 MB.
Issue 2(155034)
Description: If the controller does not support updating the encryption types parameter, a default encryption type is set
automatically during the storage volume create operation, and the storage volume modify operation fails.
Issue 3(155043)
Description: Redfish storage volume operations may return an operation progress percentage different than the actual job
status.
Resolution: It is recommended to wait for a few seconds to allow the job to reflect the actual status.
Issue 4(186024)
Description: The ome_smart_fabric_uplink module does not allow the creation of multiple uplinks of the same name even
though this is supported by OpenManage Enterprise Modular. If an uplink is created of the same name as an existing uplink, the
existing uplink is modified.
Resolution: It is recommended to use a unique name for each uplink.
Limitations
● The graceful shutdown option of the dellemc_change_power_state module is only supported on systems with iDRAC
firmware versions 3.18.18.18 and later..
● The ipmiserialprivilege_users parameter of the dellemc_configure_idrac_users module is not supported on
modular servers..
● The secure_boot_mode parameter of the dellemc_configure_bios module is only supported on iDRAC 9 based Dell EMC
PowerEdge servers.
3