Owners Manual

NOTE: The thermal grease syringe is intended for one-time use only. Dispose the syringe after you use it.
Figure 51. Applying thermal grease on top of the processor
3. Align the heat sink with the standoff screws on the system board.
CAUTION:
When installing the heat sink, ensure that the airflow arrow label is pointed towards the rear of
the system.
4. Using a Phillips #2 screwdriver, tighten the screws to secure the heat sink to the system board.
a. Partially tighten the first screw three turns.
b. Tighten the screw that is diagonally opposite to it.
5. Repeat the procedure for the remaining screws.
Figure 52. Installing the heat sink
Next steps
1. Install the heat sink.
2. Install the air shroud.
3. Follow the procedures in After working inside your system.
78
Installing and removing system components