Owners Manual

Figure 43. Installing the PERC card

Next steps

1. Install the expansion card riser.

2. Follow the procedures in After working inside your system.

Replacing the system battery

Prerequisites

NOTE:

There is a danger of a new battery exploding if it is incorrectly installed. Replace the battery only with the same or

equivalent type recommended by the manufacturer. Discard used batteries according to the manufacturer's instructions.

● Follow the safety guidelines listed in Safety instructions.

● Follow the procedures in Before working inside your system.

Steps

1. Locate the battery socket. For more information, see the system board connections section.

2. Tilt the battery partially to release it from the battery holder.

CAUTION:

To avoid damage to the battery connector, you must firmly support the connector while installing

or removing a battery.

3. Pull the battery from the battery holder.

Figure 44. Removing the system battery

Installing and removing system components