Owners Manual

Installing an expansion card into the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedures in Before working inside your system.
3. Remove the expansion card riser.
4. If installed, remove the filler bracket.
Steps
1. Flip the expansion card riser to locate the connectors on the riser.
2. Holding the card by its edges, align and insert the expansion card in the connector on the expansion card riser.
3. If applicable, connect the cables to the expansion card.
Figure 41. Installing the expansion card in the expansion card riser
Next steps
1. Install the expansion card riser.
2. Follow the procedures in After working inside your system.
Storage controller card
The NX440 contains PERC H730P internal storage controller card.
Removing the PERC card
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedures in Before working inside your system.
3. Remove the expansion card riser.
Steps
1. Remove the screw securing the blue release latch.
2. Rotate the blue release latch to disengage it from the PERC card.
3. Push the blue release latch until the tab clicks into the slot on the system.
4. Hold the PERC card by the edges and pull it to disengage it from the PERC card slot.
5. Flip the PERC card and disconnect the cable from the PERC card.
70
Installing and removing system components