Owners Manual

Reinstalling the operating system using a

DVD

If you are reinstalling the NAS operating system onto new OS drives, you need to partition the new drives. This section

describes both how to repartition the new OS drives and how to reinstall the NAS operating system.

CAUTION: Back up the internal disk drives on your system before reinstalling or upgrading the NAS Operating

System. The DVD reinstall process formats or deletes the OS disks (virtual disk 0) resulting in loss of any data

or installed applications. The DVD reinstall process does not install RASR USB Recovery application.

The standard RAID configuration for the NX440 system is:

● OS-only - RAID 5

Refer to your configuration as-shipped from Dell for details about your specific RAID configuration.

Topics:

• Recovering an OS partition

• Deploying the OS using Dell Lifecycle Controller

Recovering an OS partition

Follow this procedure to recover your OS partition if becomes corrupt.

Prerequisites

● Failed OS drives have been replaced with new, blank HDDs.

CAUTION: Do not remove or delete the original partitions on the data drives or their associated physical drives.

Steps

1. Turn on or restart your system, and press F2 to boot into System Setup.

2. Click Device Settings.

3. Click Integrated RAID Controller 1: Dell PERC <PERC H730P Mini> Configuration Utility.

4. In the Configuration Utility menu, click Virtual Disk Management.

5. Verify the following:

● Your original Data partition or partitions are shown

● No OS partition is listed

6. Click Back without making any changes to the data partitions.

7. In the Configuration Utility, click Create Virtual Disk.

8. In the Create Virtual Disk dialog box, select the RAID Level and Capacity options.

● Select RAID Level — See the standard RAID configurations above.

● Select Physical Disks From — Unconfigured Capacity.

9. Click Select Physical Disks, choose the drives to configure for RAID.

10. Click Apply Changes.

11. Wait for the Success screen to display The operation has been performed successfully, and then click OK.

12. Under Create Virtual Disk Parameters set the following options and leave remaining options set to their default settings:

● Virtual Disk Name — enter a unique name such as OS

● Virtual Disk Size — in GB (currently this partition is 140GB).

22 Reinstalling the operating system using a DVD