Owners Manual
Table Of Contents
- PowerVault NX440 Network Attached Storage System Installation and Service Manual
- Contents
- System overview
- Technical specifications
- Initial system setup and configuration
- Reinstalling the operating system using a DVD
- Diagnostics and indicators
- Pre-operating system management applications
- System Setup
- Viewing System Setup
- System Setup details
- System BIOS
- Viewing System BIOS
- System BIOS Settings details
- System Information
- Viewing System Information
- System Information details
- Memory Settings
- Viewing Memory Settings
- Memory Settings details
- Processor Settings
- Viewing Processor Settings
- Processor Settings details
- SATA Settings
- Viewing SATA Settings
- SATA Settings details
- Boot Settings
- Viewing Boot Settings
- Boot Settings details
- Integrated Devices
- Viewing Integrated Devices
- Integrated Devices details
- Serial Communication
- Viewing Serial Communication
- Serial Communication details
- System Profile Settings
- Viewing System Profile Settings
- System Profile Settings details
- System Security
- Viewing System Security
- System Security Settings details
- Creating a system and setup password
- Using your system password to secure your system
- Deleting or changing system and setup password
- Operating with setup password enabled
- Redundant OS Control
- Viewing Redundant OS Control
- Redundant OS Control screen details
- Miscellaneous Settings
- Viewing Miscellaneous Settings
- Miscellaneous Settings details
- iDRAC Settings utility
- Device Settings
- Dell Lifecycle Controller
- Boot Manager
- PXE boot
- System Setup
- Jumpers and connectors
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Front bezel
- Hard Drives
- System cover
- Cooling fans
- Intrusion switch
- System memory
- Expansion cards and expansion card riser
- Storage controller card
- Replacing the system battery
- Replacing the optional internal USB memory key
- Optical drive
- Processor and heat sink
- Drive backplane
- Power supply unit
- Power distribution board
- System board
- Trusted Platform Module
- Control panels
- Getting help
- Documentation resources
Steps
1. Hold the system board holder and lower the system board it into the system.
2. Hold the system board at an angle and align the connectors with the slots on the rear of the chassis.
3. Slide the system board towards the rear of the chassis until the connectors are firmly seated in the slots.
Figure 64. Installing the system board
4. Using a Philips #2 screwdriver, tighten the screws that secure the system board to the chassis.
Next steps
1. Replace the following:
a. TPM Module
NOTE: The TPM Module must be replaced only while installing new system board.
b. Storage controller card
c. Internal USB key (if applicable)
d. Expansion card and riser
e. Processor and heat sink
f. Memory modules
g. Air shroud
2. Reconnect the cables to the system board.
NOTE:
Ensure that the cables inside the system are routed along the chassis wall and secured using the cable securing
bracket.
3. Follow the procedures in After working inside your system.
4. Ensure that you:
a. Use the Easy Restore feature to restore the Service Tag. For more information, see the Easy restore section.
b. If the Service Tag is not backed up in the backup flash device, enter the Service Tag manually. For more information, see
the Restoring the Service Tag by using the Easy Restore feature section.
c. Update the BIOS and iDRAC versions.
d. Enable the Trusted Platform Module (TPM). For more information, see the Replacing the Trusted Platform Module
section.
5. Import your new or existing iDRAC Enterprise license.
For more information, see the Integrated Dell Remote Access Control User's Guide located at www.dell.com/idracmanuals.
Trusted Platform Module
Trusted Platform Module (TPM) is a dedicated microprocessor designed to secure hardware by integrating cryptographic keys
into devices. Software can use a TPM to authenticate hardware devices. Because each TPM chip has a unique and secret RSA
key which is embedded during the manufacture of the TPM, it is capable of performing platform authentication operations.
Installing and removing system components
87