Owners Manual

Figure 37. Removing the expansion card riser
3. If you are removing the riser permanently, install a filler bracket in the empty expansion slot and close the expansion card
latch.
4. Using a Philips #2 screw driver, tighten the screw to secure the filler bracket to the system.
Figure 38. Installing the expansion card riser filler
Next steps
1. Install the expansion card riser.
Installing the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedures in Before working inside your system.
3. Remove the air shroud
4. If removed, Install the expansion card into the riser
5. Open the expansion card riser latch
Steps
1. Align the guide on the expansion card riser with the guide pin on the system board and lower the riser until it is firmly seated.
68
Installing and removing system components