Owners Manual

Steps
Using the blue touch points, lift the air shroud out of the system.
Figure 35. Removing the air shroud
Installing the air shroud
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
Steps
1. Align the slot on the air shroud with the standoff on the chassis.
NOTE: Route the cable properly to prevent the cable from being pinched or crimped.
2. Lower the air shroud into the system until it is firmly seated.
Figure 36. Installing the air shroud
Removing the expansion card riser
Prerequisites
1. Follow the safety guidelines listed in Safety instructions.
2. Follow the procedures in Before working inside your system.
3. Remove the air shroud.
Steps
1. Open the expansion card riser latch.
2. Holding the blue touch points, lift the expansion card riser from the system.
Installing and removing system components
67