Owners Manual
Table Of Contents
- PowerVault NX440 Network Attached Storage System Installation and Service Manual
- Contents
- System overview
- Technical specifications
- Initial system setup and configuration
- Reinstalling the operating system using a DVD
- Diagnostics and indicators
- Pre-operating system management applications
- System Setup
- Viewing System Setup
- System Setup details
- System BIOS
- Viewing System BIOS
- System BIOS Settings details
- System Information
- Viewing System Information
- System Information details
- Memory Settings
- Viewing Memory Settings
- Memory Settings details
- Processor Settings
- Viewing Processor Settings
- Processor Settings details
- SATA Settings
- Viewing SATA Settings
- SATA Settings details
- Boot Settings
- Viewing Boot Settings
- Boot Settings details
- Integrated Devices
- Viewing Integrated Devices
- Integrated Devices details
- Serial Communication
- Viewing Serial Communication
- Serial Communication details
- System Profile Settings
- Viewing System Profile Settings
- System Profile Settings details
- System Security
- Viewing System Security
- System Security Settings details
- Creating a system and setup password
- Using your system password to secure your system
- Deleting or changing system and setup password
- Operating with setup password enabled
- Redundant OS Control
- Viewing Redundant OS Control
- Redundant OS Control screen details
- Miscellaneous Settings
- Viewing Miscellaneous Settings
- Miscellaneous Settings details
- iDRAC Settings utility
- Device Settings
- Dell Lifecycle Controller
- Boot Manager
- PXE boot
- System Setup
- Jumpers and connectors
- Installing and removing system components
- Safety instructions
- Before working inside your system
- After working inside your system
- Front bezel
- Hard Drives
- System cover
- Cooling fans
- Intrusion switch
- System memory
- Expansion cards and expansion card riser
- Storage controller card
- Replacing the system battery
- Replacing the optional internal USB memory key
- Optical drive
- Processor and heat sink
- Drive backplane
- Power supply unit
- Power distribution board
- System board
- Trusted Platform Module
- Control panels
- Getting help
- Documentation resources
Ports and connectors specifications
The NX440 system supports USB ports, NIC ports, VGA ports, and a serial connector.
USB ports
The NX440 supports both USB 2.0 and USB 3.0-compliant ports.
Location Type Quantity
Front panel USB 2.0-compliant port One
Front panel Micro USB 2.0-compliant port for iDRAC Direct One
Back panel USB 3.0-compliant port Two
Internal USB 3.0-compliant port One
NOTE: The micro USB 2.0-compliant port on the front panel can only be used as an iDRAC Direct or a management port.
NIC ports
The NX440 system supports two 1 GbE/10 GbE Network Interface Controller (NIC) ports on the back panel.
Serial connector
The NX440 system supports one serial connector on the back panel. The serial port is a 9-pin connector, Data Terminal
Equipment (DTE), 16550-compliant.
VGA ports
The Video Graphic Array (VGA) port enables you to connect the system to a VGA display. The NX440 system supports one
15-pin VGA port on the back panel.
Video specifications
The NX440 system supports the Integrated Matrox G200 graphics controller with 16 MB of video frame buffer.
Resolution
Refresh Rate (Hz) Color Depth (bit)
640 x 480 60, 70 8, 16, 24
800 x 600 60, 75, 85 8, 16, 24
1024 x 768 60, 75, 85 8, 16, 24
1152 x 864 60, 75, 85 8, 16, 24
1280 x 1024 60, 75 8, 16, 24
Environmental specifications
For additional information about environmental measurements for specific system configurations, see dell.com/
environmental_datasheets.
Temperature
16 Technical specifications