Users Guide

Figure 2. VEP1405 series desktop placement

Wall mount installation

The VEP1405 series includes the hardware that is required for wall mount installation. Using a torque screwdriver, affix the wall mount

brackets to the VEP1405 series using the four M3 screws included.

NOTE: When driving the screws into the bracket and VEP1405 series unit, verify that 5 lb-in is the achieved torque

setting.

NOTE: If mounting the VEP1405 series to the wall using the wall mount bracket provided, removal of the rubber feet

from the bottom of the VEP1405 series unit is not necessary.

The VEP1405 series of systems include a wall mount bracket with cross-shaped cutout for the mounting screws. The wall mount bracket

includes cross-shaped cutouts for the mounting screws.

Wall mount bracket with cross-shaped cutout for the mounting screws

Figure 3. VEP1405 series wall mount installation - cross-shaped cutout

To mount the VEP1405 series unit to the wall using the wall mount bracket provided, you must first anchor the screws into the wall

surface. Depending on the type of wall surface, use the M3 screw and anchor to ensure a secure installation. The recommended M3

screw dimensions are as follows:

Site Preparations