Users Guide
Table Of Contents
- Dell EMC Networking Virtual Edge Platform 1405 Series Getting Started Guide
- Contents
- About this Guide
- Site Preparations
- VEP1405 Series Installation
- Specifications
- Chassis physical design
- Safety standards and compliance agency certifications
- Product recycling and disposal
- Agency compliance
- USA Federal Communications Commission statement
- Industry Canada Statement
- Radiocommunication equipment compliance for Thailand
- Brasil – Aviso da Anatel
- European Union EMC directive conformance statement
- Japan VCCI compliance for Class A equipment
- Korean certification of compliance
- Mexico certification of compliance
- Taiwanese certification of compliance
- Singapore certification of compliance
- Support
Figure 4. VEP1405 series wall mount, installation anchor, and screw dimensions
NOTE:
Before mounting the VEP1405 series to the wall, verify that the wall surface is strong enough to support a firm
installation of the unit and can withstand the weight of the unit, power cable, and network cabling.
Using the measurements provided in the following diagram, use the measurement in the red box to mark the distance between
the two installation points:
Figure 5. VEP1405 series M3 screw installation points
After the brackets have been attached to the VEP1405 series unit and the screws that are mounted into the wall, place the
brackets over the screws and slide the unit to one side to secure the unit in place.
8
Site Preparations