Users Guide
Table Of Contents
- Dell EMC Networking Virtual Edge Platform 1405 Series Getting Started Guide
- Contents
- About this Guide
- Site Preparations
- VEP1405 Series Installation
- Specifications
- Chassis physical design
- Safety standards and compliance agency certifications
- Product recycling and disposal
- Agency compliance
- USA Federal Communications Commission statement
- Industry Canada Statement
- Radiocommunication equipment compliance for Thailand
- Brasil – Aviso da Anatel
- European Union EMC directive conformance statement
- Japan VCCI compliance for Class A equipment
- Korean certification of compliance
- Mexico certification of compliance
- Taiwanese certification of compliance
- Singapore certification of compliance
- Support
NOTE: For a listing of the supported optics guidelines for the VEP1405 series, see the Virtual Edge Platform 1405 Series
Technology Guide.
Figure 9. VEP1405 series front view
1. Security lock port
2. USB port
NOTE: An additional USB port is located on the opposite side of the system.
3. System status indicator LED
Table 3. Front view system status indicator LED
Color Status
Red Power on
White System is booting
Green Operating system boots with diagOS
Blue Reset button is pressed for more than five seconds
NOTE: See the Reset button behavior table below for more information.
Figure 10. VEP1405 series rear view (with port cover)
1. Port cover
2. Reset button
NOTE: See the Reset button behavior table below for more information.
3. LED status indicators for SFP+ ports
4. SFP+ ports
5. Ethernet ports and LED status indicators
6. Power connection port
NOTE:
To prevent the VEP1405 series system console port from being accessed in a nonsecure location, the system
ships from the factory with a plate covering the micro USB port. To uncover the port, use a #0 (2.5 mm) Phillips head
screwdriver to loosen or remove the screw that holds the plate in place.
Specifications 13