Setup Guide

94 Dell EMC PowerEdge MX SmartFabric Configuration and Troubleshooting Guide
Error: I/O Module is not in fabric mode
2. Configuration of the breakout requires you to select the HardwareDefault breakout type first. If the
breakout type is directly selected without first selecting HardwareDefault, the following error displays:
Error: interface fanout type is not hardware default
3. Once the uplinks are added, they are most often associated with tagged or untagged VLANs. When
attempting to configure the breakout on the uplink port-groups after adding uplinks associated with
VLANs to the fabric, the following error displays:
Error: Breakout failed