Setup Guide

89 Dell EMC PowerEdge MX SmartFabric Configuration and Troubleshooting Guide
11.6.1.2 Verify physical interface configuration
The physical, host-connected, interfaces in the validated environment are those connected directly to the
PowerEdge R730xd servers (and the jump box, if used) as shown in Figure 66.
Verify the physical interfaces from the Cisco ACI fabric to the servers are up and properly configured to allow
designated VLANs and EPGs. This is done as follows:
1. In the APIC GUI, go to Fabric > Inventory > Pod 1 > Leaf name > Interfaces > Physical
Interfaces as shown in Figure 80.
Cisco ACI physical interfaces
2. Verify that all required interfaces, for example, eth1/1-3, are up.