Setup Guide

66 Dell EMC PowerEdge MX SmartFabric Configuration and Troubleshooting Guide
9.2 Dell EMC PowerSwitch Z9100-ON validation
This section contains validation commands for the Dell EMC PowerSwitch Z9100-ON leaf switches.
9.2.1 show vlt
The show vlt command validates the VLT configuration status when the VLTi Link Status is up. The role of
one switch in the VLT pair is primary, and its peer switch (not shown) is assigned the secondary role.
Z9100-Leaf1# show vlt 1
Domain ID : 1
Unit ID : 1
Role : primary
Version : 1.0
Local System MAC address : 4c:76:25:e8:f2:c0
VLT MAC address : 4c:76:25:e8:f2:c0
IP address : fda5:74c8:b79e:1::1
Delay-Restore timer : 90 seconds
Peer-Routing : Disabled
Peer-Routing-Timeout timer : 0 seconds
VLTi Link Status
port-channel1000 : up
VLT Peer Unit ID System MAC Address Status IP Address
Version
--------------------------------------------------------------------------------
2 4c:76:25:e8:e8:40 up fda5:74c8:b79e:1::2 1.0
9.2.2 show lldp neighbors
The show lldp neighbors command provides information about connected devices. In this case,
ethernet1/1/1 and ethernet1/1/3 connect to the two MX9116n FSEs, C160A2 and C140A1. The
remaining links,
ethernet1/1/29 and ethernet 1/1/31, represent the VLTi connection.
Z9100-Leaf1# show lldp neighbors
Loc PortID Rem Host Name Rem Port Id Rem Chassis Id
----------------------------------------------------------------
ethernet1/1/1 C160A2 ethernet1/1/41 20:04:0f:00:a1:9e
ethernet1/1/3 C140A1 ethernet1/1/41 20:04:0f:00:cd:1e
ethernet1/1/29 Z9100-Leaf2 ethernet1/1/29 4c:76:25:e8:e8:40
ethernet1/1/31 Z9100-Leaf2 ethernet1/1/31 4c:76:25:e8:e8:40
9.2.3 show spanning-tree brief
The show spanning-tree brief command validates that STP is enabled on the leaf switches. All
interfaces are forwarding
(FWD), as shown in the Sts column.
Z9100-Leaf1# show spanning-tree brief
Spanning tree enabled protocol rapid-pvst