Setup Guide

20 Dell EMC PowerEdge MX SmartFabric Configuration and Troubleshooting Guide
3.3 Spanning Tree Protocol
By default, OS10EE uses Rapid per-VLAN Spanning Tree Plus (RPVST+) across all switching platforms
including PowerEdge MX networking IOMs. OS10EE also supports RSTP. MST is not currently supported
when using VLT, and therefore is not supported in SmartFabric mode.
NOTE: Dell EMC recommends using RSTP when more than 64 VLANs are required in a fabric to avoid
performance problems.
Caution should be taken when connecting an RPVST+ to an existing RSTP environment. RPVST+ creates a
single topology per VLAN with the default VLAN, typically VLAN 1, for the Common Spanning Tree (CST) with
RSTP.
For non-native VLANs, all bridge protocol data unit (BPDU) traffic is tagged and forwarded by the upstream,
RSTP-enabled switch, with the associated VLAN. These BPDUs use a protocol-specific multicast address.
Any other RPVST+ tree attached to the RSTP tree might processes these packets accordingly leading to the
potential of unexpected trees.
NOTE: When connecting to an existing environment that is not using RPVST+, Dell EMC Networking
recommends changing to the existing spanning tree protocol before connecting an OS10EE switch. This ensures
same type of Spanning Tree is run on the OS10EE MX switches and the upstream switches.
To switch from RPVST+ to RSTP, use the spanning-tree mode rstp command:
MX9116N-A1(config)# spanning-tree mode rstp
MX9116N-A1(config)# end
To validate the STP configuration, use the
show spanning-tree brief command:
MX9116N-A1#show spanning-tree brief
Spanning tree enabled protocol rstp with force-version rstp
Executing IEEE compatible Spanning Tree Protocol
Root ID Priority 0, Address 4c76.25e8.f2c0
Root Bridge hello time 2, max age 20, forward delay 15
Bridge ID Priority 32768, Address 2004.0f00.cd1e
Configured hello time 2, max age 20, forward delay 15
Flush Interval 200 centi-sec, Flush Invocations 95
Flush Indication threshold 0 (MAC flush optimization is disabled)
NOTE: STP is required. Operating a SmartFabric with STP disabled will create network loops and is not
supported.
3.4 VLAN scaling guidelines
Because SmartFabric mode provides network automation capabilities that Full Switch mode does not, the
number of recommended VLANs differs between the modes. Table 5 provides the recommended maximum
number of VLANs per fabric, Uplink, and server port for each OS10EE release for RSTP.
NOTE: These are recommendations, not enforced maximums.