Users Guide

frames for dot1p 4 traffic using the pfc-cos dot1p-priority command. The no version of this command
resets to the default value.
Example
OS10(config)# iscsi priority-bits 0x20
Supported
Releases
10.3.0E or later
iscsi profile-storage
Configures a port for direct connection to a storage device that is not automatically detected by iSCSI.
Syntax
iscsi profile-storage storage-device-name
Parameter storage-device-name — Enter a user-defined name of a storage array that iSCSI does not automatically
detect.
Default Not configured
Command Mode INTERFACE
Usage Information Configure directly attached storage arrays that iSCSI supports if they are not automatically detected. This
command is required for storage devices that do not support LLDP. The no version of this command disables the
connection.
Example
OS10(conf-if-eth1/1/2)# iscsi profile-storage compellant
Supported
Releases
10.3.0E or later
iscsi session-monitoring enable
Enables iSCSI session monitoring.
Syntax
iscsi session-monitoring enable
Parameter None
Default Disabled
Command Mode CONFIGURATION
Usage Information To configure the aging timeout in iSCSI monitoring sessions, use the iscsi aging time command. To
configure the TCP ports that listen for connected storage devices in iSCSI monitoring sessions use the iscsi
target port command. The no version of this command disables iSCSI session monitoring.
Example
OS10(config)# iscsi session-monitoring enable
Supported
Releases
10.3.0E or later
iscsi target port
Configures the TCP ports that are used to monitor iSCSI sessions with target storage devices.
Syntax
iscsi target port tcp-port1 [tcp-port2, ..., tcp-port16] [ip-address ip-
address]
Parameters
• tcp-port — Enter one or more TCP port numbers, from 0 to 65535. Separate TCP port numbers with a
comma.
• ip-address ip-address — (Optional) Enter the IP address in A.B.C.D format of a storage array whose
iSCSI traffic is monitored on the TCP port.
Default 3260,860
Command Mode CONFIGURATION
1238 Converged data center services