Users Guide

Example
OS10(conf-if-eth1/1/2)# dcbx tlv-select ets-conf pfc
Supported
Releases
10.3.0E or later
dcbx version
Configures the DCBX version that is used on a port interface.
Syntax
dcbx version {auto | cee | ieee}
Parameters
• auto — Automatically select the DCBX version based on the peer response.
• cee — Set the DCBX version to CEE.
• ieee — Set the DCBX version to IEEE 802.1Qaz.
Default Auto
Command Mode INTERFACE
Usage Information In Auto mode, a DCBX-enabled port detects an incompatible DCBX version on a peer device port and
automatically reconfigures a compatible version on the local port. The no version of this command disables the
DCBX version.
Example
OS10(conf-if-eth1/1/2)# dcbx version cee
Supported
Releases
10.3.0E or later
lldp tlv-select dcbxp
Enables and disables DCBX on a port interface.
Syntax
lldp tlv-select dcbxp
Parameters None
Default Enabled interface level; disabled global level
Command Mode INTERFACE
Usage Information DCBX must be enabled at both the global and interface levels. Enable DCBX globally using the dcbx enable
command to activate the exchange of DCBX TLV messages with PFC, ETS, and iSCSI configurations. To
configure the TLVs advertised by a DCBX-enabled port, change the DCBX version, or disable DCBX on an
interface, use DCBX interface-level commands. The no version of this command disables DCBX on an interface.
Example
OS10(conf-if-eth1/1/1)# lldp tlv-select dcbxp
Supported
Releases
10.3.0E or later
show lldp dcbx interface
Displays the DCBX configuration and PFC or ETS TLV status on an interface.
Syntax
show lldp dcbx interface ethernet node/slot/port[:subport] [ets detail | pfc detail]
Parameters
• interface ethernet node/slot/port[:subport] — Enter interface information.
• ets detail — Display the ETS TLV status and operation with DCBX peers.
• pfc detail — Display the PFC TLV status and operation with DCBX peers.
Default Not configured
Command Mode EXEC
Converged data center services 1231