Users Guide

trust-map
Configures trust map on an interface or on a system QoS.
Syntax
trust—map {dot1p | dscp} {default | trust-map-name}
Parameters
• dot1p — Apply dot1p trust map.
• dscp — Apply dscp trust map.
• default — Apply default dot1p or dscp trust map.
• trust-map-name — Enter the name of trust map.
Default Disabled
Command Mode
INTERFACE
SYSTEM-QoS
Usage Information Use the show qos maps type [tc-queue | trust-map-dot1p | trust-map-dscp] [trust-
map-name] command to view the current trust mapping. You must change the trust map only during no traffic
flow. Verify the correct policy maps are applied. The no version of this command returns the value to the default.
The no version of this command removes the applied trust map from the interface or system QoS.
Example
OS10(config)# interface ethernet 1/1/10
OS10(conf-if-eth1/1/10)# trust-map dot1p default
OS10(conf-if-eth1/1/10)# trust-map dot1p d1
OS10(config)# interface ethernet 1/1/2
OS10(conf-if-eth1/1/2)# trust-map dscp default
OS10(conf-if-eth1/1/2)# trust-map dscp d2
OS10(config)# system qos
OS10(config-sys-qos)# trust-map dot1p default
OS10(config-sys-qos)# trust-map dscp d2
Supported
Releases
10.4.1.0 or later
wred
Configures a weighted random early detection (WRED) profile.
Syntax
wred wred-profile-name
Parameters wred-profile-name — Enter a name for the WRED profile.
Default Not configured
Command Mode CONFIGURATION
Usage Information The no version of this command removes the WRED profile.
Example
OS10(config)# wred test_wred
OS10(config-wred)#
Supported
Releases
10.4.0E(R1) or later
Quality of service 1169