Users Guide

Usage
Information
● The configurations are supported only in the multiswitch mode.
● This command configures the cost of the selected interface. Also, it configures the same cost value
on both ends of the link.
● Different cost values lead to repeat the request repeatedly or even indefinitely.
● The no version of this command resets the command to default value, for the interface speed.
Example
OS10(config-if-fc-1/1/1)#fspf cost 90
Supported
Releases
10.5.1.0 or later
fspf dead-interval
Configures the FSPF dead Interval value for every interface.
Syntax
fspf dead-interval timeout-val
Parameters
timeout-val—Valid values are from 1 to 65535.
Defaults 80 s
Command Mode Fiber channel INTERFACE
Usage
Information
● The configurations are supported only in the multiswitch mode.
● This command specifies the maximum interval. You must first receive a hello message on the selected
interface before the neighbor is considered lost and removed from the database.
● The no form of this command resets the command to default value, 80 s.
Example
OS10(config-if-fc-1/1/1)#fspf dead-interval 90
Supported
Releases
10.5.1.0 or later
fspf hello-interval
Configures the FSPF hello interval value for every interface.
Syntax
fspf hello-interval timeout-val
Parameters
timeout-val—Valid values are from 1 to 65535.
Defaults 20 s
Command Mode Fiber Channel INTERFACE
Usage
Information
● The configurations are supported only in multiswitch mode.
● This command specifies the hello message interval to verify the health of the link in the VSAN.
● The no version of this command resets to the default value.
Example
OS10(config-if-fc-1/1/1)#fspf hello-interval 30
Supported
Releases
10.5.1.0 or later
fspf hold-time
Configures the FSPF hold-time value for vfabric.
Syntax
fspf hold-time timeout-val
362 Fibre Channel