Users Guide

Parameters
● vrf vrf-name — (Optional) Enter vrf and then the name of the VRF to configure a static route
corresponding to that VRF. Use this VRF option after the ip route keyword to configure a static
route on that specific VRF.
● dest-ip-prefix — Enter the destination IP prefix in dotted decimal A.B.C.D format.
● mask — Enter the mask in slash prefix-length /x format.
● next-hop — Enter the next-hop IP address in dotted decimal A.B.C.D format.
● interface interface-type — Enter the interface type and interface information. The interface
types supported are: Ethernet, port-channel, VLAN, and Null.
● route-preference — (Optional) Enter the range, from 1 to 255.
Default Not configured
Command Mode CONFIGURATION
Usage
Information
The no version of this command deletes a static route configuration.
Example
OS10(config)# ip route 200.200.200.0/24 10.1.1.2
OS10(config)# ip route 200.200.200.0/24 interface null 0
Supported
Releases
10.2.0E or later
show ip arp
Displays the ARP table entries for a specific IP address or MAC address, static, dynamic, and a summary of all ARP entries.
Syntax
show ip arp [vrf vrf-name] [interface [ethernet | vlan | port-channel] | ip-address
| mac-address | static | dynamic | summary]
Parameters
● vrf vrf-name — Enter vrf then the name of the VRF to display ARP entries corresponding to that VRF.
● interface — (Optional) Enter the keyword and interface information:
○ ethernet — Enter the node/slot/port[:subport] information.
○ vlan — Enter the VLAN ID number, from 1 to 4093.
○ port-channel — Enter the port-channel ID number, from 1 to 128.
● ip-address — (Optional) Enter the IP address for the ARP entry in A.B.C.D format.
● mac-address — (Optional) Enter the MAC address in nn:nn:nn:nn:nn:nn format.
● static — (Optional) Enter the keyword to display static ARP entries.
● dynamic — (Optional) Enter the keyword to display dynamic ARP entries.
● summary — (Optional) Enter the keyword to display a summary of all ARP entries.
Default Not configured
Command Mode EXEC
Usage
Information
This command shows both static and dynamic ARP entries.
Example (IP
Address)
OS10# show ip arp 192.168.2.2
Address Hardware address Interface Egress Interface
--------------------------------------------------------------------
192.168.2.2 90:b1:1c:f4:a6:e6 ethernet1/1/49:1 ethernet1/1/49:1
Example (Static)
OS10# show ip arp summary
Total Entries Static Entries Dynamic Entries
662 Layer 3