Install Guide
Static IP addresses
Dell EMC recommends conguring the switch module through the blade server chassis management GUI, namely, Dell EMC OpenManage
Enterprise Modular. Use this management GUI to congure the switch IP address and perform advanced conguration tasks. By default,
the IP address mode is set to DHCP. Use this GUI to assign a static IP address. To congure the FC switch module, follow these steps:
1 Log in to the blade server chassis management GUI application.
Figure 9. OpenManage Enterprise modular
2 Select Devices > I/O modules.
The I/O modules display.
NOTE: You may also access the WebTools conguration UI to manage the switch module by typing the switch module IP
address into any supported web browser.
Figure 10. I/O modules list
3 Select the I/O module name, IP address, or View Details on the right side of the display.
The Overview tab is displayed. Select the Settings tab.
Figure 11. Settings tab
4 Click and expand the Network option. Select the required check boxes, and complete the IPv4 or IPv6 settings, DNS server settings,
and optionally the management VLAN ID. Click Apply.
Initial setup and
verication 27