Users Guide

Bottom view
Features
1 GPIO-in 8-pin port
1, 2, 4
Connect to a GPIO-out enabled device or dongle. For more
information, see GPIO-in connector mapping.
2 GPIO-out 8-pin port
2, 3, 4
Connect to a GPIO-in enabled device or dongle. For more
information, see GPIO-out connector mapping.
3 USB 2.0 ports (4) Connect USB enabled devices. Provides data transfer speeds up to
480 Mbps.
4 Network status light one Indicates the network activity of network port one.
5 Power status light Indicates the power‑state of the Embedded Box PC.
6 Hard-drive activity light Turns on when the Embedded Box PC reads from or writes to the
internal storage device.
7 Network status light two Indicates the network activity of the network port two.
8 Mobile broadband antenna port two Connect a mobile broadband antenna to increase the range and
strength of the mobile broadband signals.
9 RS232/RS422/RS485 port four (configurable in the
BIOS)
Connect an RS232/RS422/RS485 cable to the Embedded Box PC.
For more information, see RS232/RS422/RS485 connector mapping.
10 Mobile broadband antenna port one Connect a mobile broadband antenna to increase the range and
strength of mobile broadband signals.
11 RS232/RS422/RS485 port three (configurable in the
BIOS)
Connect an RS232/RS422/RS485 cable to the Embedded Box PC.
For more information, see RS232/RS422/RS485 connector mapping.
12 RS232/RS422/RS485 port two (configurable in the
BIOS)
Connect an RS232/RS422/RS485 cable to the Embedded Box PC.
For more information, see RS232/RS422/RS485 connector mapping.
13 Wireless antenna port two Connect a wireless antenna to increase the range and strength of
wireless signals.
14 RS232/RS422/RS485 port one (configurable in the
BIOS)
Connect an RS232/RS422/RS485 cable to the Embedded Box PC.
For more information, see RS232/RS422/RS485 connector mapping.
15 Wireless antenna port one Connect a wireless antenna to increase the range and strength of
wireless signals.
1 The GPIO-in port has 9 pins. Pin labels are GND and GP10 through GP17.
2 Connections made to these ports must use SELV circuits and the wire (26 AWG-18 AWG) must have Double Insulation (DI) or Reinforced Insulation (RI) to protect it from all
hazardous voltages. Torque the screws at 2.88 kg-cm (2.5 lb-in) to secure the wire to the connector.
3 The GPIO-in port has 9 pins. Pin labels are GND and GP00 through GP07.
4 Connections made to the GPIO-in/out port must use SELV circuits (30 Vmax) and must be protected by Double/Reinforced Insulation (DI)/(RI) from all hazardous voltages.
5 The antenna is shipped in a separate accessory box along with your Edge Gateway.
Features 9