Service Manual

Replacing the Dell logo board

OPOMBA Before working inside your Embedded Box PC, read the safety information that shipped with your Embedded

Box PC and follow the steps in Before working inside your Embedded Box PC. After working inside your Embedded Box

PC, follow the steps in After working inside your Embedded Box PC. For more safety best practices, see the Regulatory

Compliance home page at www.dell.com/regulatory_compliance.

Teme:

• Procedure

• Post-requisites

Procedure

1. Place the Dell logo board into the front chassis.

2. Replace the screws that secure the Dell logo board to the chassis.

3. Align the screw holes on the left chassis with the screw holes on the front chassis.

4. Replace the screws that secure the left chassis to the front chassis.

Post-requisites

1. Replace the CPU board.

2. Follow step 2 to step 6 in Replacing the top cover.

3. Replace the power connectors.

4. Replace the riser card.

5. Replace the heat sink.

6. Replace the memory module.

7. Replace the bottom cover.

8. Replace the intrusion switch.

9. Replace the SIM card.

10. Replace the CANbus card or WWAN card.

11. Replace the WWAN-antenna connectors.

12. Replace the WLAN card.

13. Replace the WLAN-antenna connectors.

14. Replace the PCI/PCIe card (if necessary).

15. Follow step 2 to step 8 in “Replacing the back cover”.

98 Replacing the Dell logo board