Service Manual

Removing the power switch
OPOMBA Before working inside your Embedded Box PC, read the safety information that shipped with your Embedded
Box PC and follow the steps in Before working inside your Embedded Box PC. After working inside your Embedded Box
PC, follow the steps in After working inside your Embedded Box PC. For more safety best practices, see the Regulatory
Compliance home page at www.dell.com/regulatory_compliance.
Teme:
• Prerequisites
• Procedure
Prerequisites
1. Follow step 1 to step 6 in “Removing the back cover”.
2. Remove the PCI/PCIe card (if installed).
3. Remove the CANbus cable.
4. Remove the riser card.
5. Remove the power connectors.
6. Remove the top cover.
Procedure
1. To release the power switch from the top cover, press the tabs on the power switch.
2. Route the power switch and power-switch cable thought the slot on the top cover.
1.
top cover 2. power switch
3. tabs (2) 4. power-switch cable
49
Removing the power switch 83