Service Manual

Replacing the WLAN card

OPOMBA Before working inside your Embedded Box PC, read the safety information that shipped with your Embedded

Box PC and follow the steps in Before working inside your Embedded Box PC. After working inside your Embedded Box

PC, follow the steps in After working inside your Embedded Box PC. For more safety best practices, see the Regulatory

Compliance home page at www.dell.com/regulatory_compliance.

Teme:

• Procedure

• Post-requisites

Procedure

OPOMBA

To avoid damage to the WLAN card, do not place any cables under it.

1. Align the notch on the WLAN card with the tab on the mPCIE2 slot.

2. Insert the WLAN card at an angle into the mPCIE2 slot.

3. Insert the WLAN-card bracket into the WLAN card.

4. Align the screw holes on the WLAN-card bracket with the screw holes on the system board.

5. Replace the screws that secure the WLAN-card bracket to the system board.

6. Connect the antenna cables to the WLAN card.

The following table provides the antenna-cable color scheme for the WLAN card supported by the Embedded Box PC.

Connectors on the WLAN card

Antenna-cable color

Main (white triangle) White

Auxiliary (black triangle) Black

Replacing the WLAN card 41