Service Manual

Removing the drives from the hard-drive cage

OPOMBA Before working inside your Embedded Box PC, read the safety information that shipped with your Embedded

Box PC and follow the steps in Before working inside your Embedded Box PC. After working inside your Embedded Box

PC, follow the steps in After working inside your Embedded Box PC. For more safety best practices, see the Regulatory

Compliance home page at www.dell.com/regulatory_compliance.

POZOR Hard drives/solid-state drives are fragile. Exercise care when handling the Solid-state/hard drive.

POZOR To avoid data loss, do not remove the hard drive/solid-state drive while the Embedded Box PC is in sleep or on

state.

Teme:

• Prerequisites

• Procedure

Prerequisites

Follow step 1 to step 6 in “Removing the back cover”.

Procedure

OPOMBA

Embedded Box PC is shipped with hard drive, solid-state drive, or both, depending on the configuration

ordered.

1. Remove the screws that secure the top drive to the hard-drive cage.

2. Slide the top drive out of the hard-drive cage.

back cover 2. STDF (L5.1), M3x3 screws (4)

3. hard-drive cage 4. hard drive/solid-state drive

Procedure to remove bottom drive

1. Remove the screws that secure the bottom drive to the hard-drive cage.

2. Lift and slide the bottom drive out of the hard-drive cage.

Removing the drives from the hard-drive cage 19