Service Manual

Removing the top cover

NOTE: Before working inside your Embedded Box PC, read the safety information that shipped with your Embedded Box

PC and follow the steps in Before working inside your Embedded Box PC. After working inside your Embedded Box PC,

follow the steps in After working inside your Embedded Box PC. For more safety best practices, see the Regulatory

Compliance home page at www.dell.com/regulatory_compliance.

Topics:

• Prerequisites

• Procedure

Prerequisites

1. Follow step 1 to step 6 in “Removing the back cover”.

2. Remove the PCI/PCIe card (if installed).

3. Remove the CANbus cable.

4. Remove the riser card.

5. Remove the power connectors.

Procedure

1. Disconnect the power-switch cable and remove it from the routing guides on the chassis.

2. Remove the hexagonal screws that secure the VGA port to the top cover.

#4 40UNCx6.3 hexagonal screws (2) 2. VGA port

3. routing guides (4) 4. power-connector cable

5. chassis

3. Remove the screws that secure the top cover to the chassis.

80 Removing the top cover