Service Manual

Removing the CANbus cable

NOTE: Before working inside your Embedded Box PC, read the safety information that shipped with your Embedded Box

PC and follow the steps in Before working inside your Embedded Box PC. After working inside your Embedded Box PC,

follow the steps in After working inside your Embedded Box PC. For more safety best practices, see the Regulatory

Compliance home page at www.dell.com/regulatory_compliance.

Topics:

• Prerequisites

• Procedure

Prerequisites

1. Follow step 1 to step 6 in “Removing the back cover”.

2. Remove the PCI/PCIe card (if installed).

Procedure

1. Disconnect the CANbus cable from the connector on the CANbus card.

2. Remove the CANbus cable from the routing guides on the chassis.

3. Slide the cable out from under the heat sink pipe.

4. Remove the hexagonal screws that secure the CANbus port to the top cover.

5. Lift the CANbus cable from the Embedded Box PC.

#4 40UNCx6.3 hexagonal screws (2) 2. CANbus port

Removing the CANbus cable 53