Service Manual

Removing the WLAN card

NOTE: Before working inside your Embedded Box PC, read the safety information that shipped with your Embedded Box

PC and follow the steps in Before working inside your Embedded Box PC. After working inside your Embedded Box PC,

follow the steps in After working inside your Embedded Box PC. For more safety best practices, see the Regulatory

Compliance home page at www.dell.com/regulatory_compliance.

Topics:

• Prerequisites

• Procedure

Prerequisites

1. Follow step 1 to step 6 in “Removing the back cover”.

2. Remove the PCI/PCIe card (if installed).

Procedure

1. Disconnect the antenna cables connected to the WLAN card.

2. Remove the screws that secure the WLAN-card bracket to the system board.

3. Remove the WLAN-card bracket from the WLAN card.

4. Slide and remove the WLAN card from the mPCIE2 slot.

WLAN-antenna cables (2) 2. WLAN-card bracket

3. M2x3 screws (2) 4. mPCIE2 slot

5. WLAN card

40 Removing the WLAN card