Service Manual

Removing the WLAN-antenna connectors

NOTE: Before working inside your Embedded Box PC, read the safety information that shipped with your Embedded Box

PC and follow the steps in Before working inside your Embedded Box PC. After working inside your Embedded Box PC,

follow the steps in After working inside your Embedded Box PC. For more safety best practices, see the Regulatory

Compliance home page at www.dell.com/regulatory_compliance.

Topics:

• Prerequisites

• Procedure

Prerequisites

1. Follow step 1 to step 6 in “Removing the back cover”.

2. Remove the PCI/PCIe card (if installed).

Procedure

1. Remove the nuts and washers that secure the WLAN-antenna connectors one and two to the chassis.

2. Push the WLAN-antenna connectors through the chassis.

a. chassis

b. WLAN-antenna connectors two

c. WLAN-antenna connectors one

3. Disconnect the antenna cables from the WLAN card.

4. Remove the WLAN-antenna cables from the WLAN-cable routing guides on the chassis.

5. Remove the WLAN-antenna cable off the chassis.

Removing the WLAN-antenna connectors 37