Service Manual

Replacing the interposer board

NOTE: Before working inside your Embedded Box PC, read the safety information that shipped with your Embedded Box

PC and follow the steps in Before working inside your Embedded Box PC. After working inside your Embedded Box PC,

follow the steps in After working inside your Embedded Box PC. For more safety best practices, see the Regulatory

Compliance home page at www.dell.com/regulatory_compliance.

Topics:

• Procedure

• Post-requisites

Procedure

1. Align the screw holes on the interposer board with the screw holes on the solid-state drive card bracket.

2. Replace the screws that secure the interposer board to the solid-state drive card bracket.

Post-requisites

1. Replace the solid-state drive in to bracket.

2. Replace the drives in to the hard-drive cage.

3. Follow step 2 to step 8 in “Replacing the back cover”.

Replacing the interposer board 25