Service Manual

Removing the interposer board

NOTE: Before working inside your Embedded Box PC, read the safety information that shipped with your Embedded Box

PC and follow the steps in Before working inside your Embedded Box PC. After working inside your Embedded Box PC,

follow the steps in After working inside your Embedded Box PC. For more safety best practices, see the Regulatory

Compliance home page at www.dell.com/regulatory_compliance.

Topics:

• Prerequisites

• Procedure

Prerequisites

1. Follow step 1 to step 6 in “Removing the back cover”.

2. Remove the drives from the hard-drive cage.

3. Remove the solid-state drive from bracket.

Procedure

1. Remove the screws that secure the interposer board to the solid-state drive card bracket.

2. Lift the interposer board off the solid-state drive card bracket.

a. M2x3 screws (3)

b. interposer board

c. solid-state drive card bracket.

24 Removing the interposer board