Service Manual

Removing the solid-state drive from bracket

NOTE: Before working inside your Embedded Box PC, read the safety information that shipped with your Embedded Box

PC and follow the steps in Before working inside your Embedded Box PC. After working inside your Embedded Box PC,

follow the steps in After working inside your Embedded Box PC. For more safety best practices, see the Regulatory

Compliance home page at www.dell.com/regulatory_compliance.

CAUTION: Solid-state drives are fragile. Exercise care when handling the solid-state drive.

Topics:

• Prerequisites

• Procedure

Prerequisites

1. Follow step 1 to step 6 in “Removing the back cover”.

2. Remove the drives from the hard-drive cage.

Procedure

NOTE:

Embedded Box PC is shipped with hard drive, solid-state drive, or both, depending on the configuration ordered.

1. Remove the screw that secures the solid-state drive to the solid-state drive bracket.

2. Remove the solid-state drive from the solid-state drive slot.

solid-state drive slot 2. solid-state drive

3. solid-state drive bracket 4. M2x3 screw

22 Removing the solid-state drive from bracket