Service Manual

Replacing the drives in to the hard-drive cage

NOTE: Before working inside your Embedded Box PC, read the safety information that shipped with your Embedded Box

PC and follow the steps in Before working inside your Embedded Box PC. After working inside your Embedded Box PC,

follow the steps in After working inside your Embedded Box PC. For more safety best practices, see the Regulatory

Compliance home page at www.dell.com/regulatory_compliance.

CAUTION: Hard drives/solid-state drives are fragile. Exercise care when handling the Solid-state/hard drive.

Topics:

• Procedure

• Post-requisites

Procedure

NOTE: If the Embedded Box PC is shipped with two drives, the bottom drive has to be replaced first. For more

information see, Procedure to replace bottom drive.

1. Insert the drive into the hard-drive cage.

2. Align the screw holes on the drive with the screw holes on the hard-drive cage.

3. Replace the screws that secure the hard drive to the hard-drive cage.

Procedure to replace bottom drive

1. Insert the bottom drive into the bottom slot of the hard-drive cage and push it down into place.

2. Align the screw holes on the bottom drive with the screw holes on the hard-drive cage.

3. Replace the screws that secure the bottom drive to the hard-drive cage.

Post-requisites

Follow step 2 to step 8 in “Replacing the back cover”.

Replacing the drives in to the hard-drive cage 21