Users Guide
Table Of Contents
- Dell Embedded Box PC 3000
- Overview
- Features
- Setting up the Embedded Box PC
- Setting up your operating system
- Ubuntu Desktop
- Windows OS
- Windows 7 Professional SP1
- Windows 7 Professional for Embedded Systems SP1
- Windows Embedded Standard 7 P/E
- Windows 10 Professional
- Windows 10 IoT Enterprise LTSB 2015
- Recommended drivers and applications for Embedded Box PC running Windows operating system
- Specifications
- Activating your mobile broadband service
- Using the Multi-function port cable
- Setting up the ZigBee Dongle
- Connector kit
- BIOS defaults
- Contacting Dell
Features
7 Wireless antenna port one Connect a wireless antenna to increase the range and strength of the
wireless signals.
8 Wireless antenna port two Connect a wireless antenna to increase the range and strength of the
wireless signals.
9 Remote power switch
1
Install a remote power switch.
10 RS232/RS485 port three (configurable in the BIOS) Connect a RS232/RS485 cable to the Embedded Box PC. For more
information, see RS232/RS485 connector mapping.
11 USB 2.0 port Connect a USB enabled device. Provides data transfer speeds up to
480 Mbps.
12 USB 2.0 port Connect a USB enabled device. Provides data transfer speeds up to
480 Mbps.
13 Network port two Connect an Ethernet (RJ45) cable for network access. Provides data
transfer speeds up to 10/100/1000 Mbps.
14 CANbus port (optional) Connect to a CANbus port enabled device or dongle. For more
information, see CANbus connector mapping.
15 DisplayPort Connect a monitor or another DisplayPort enabled device. Provides
video and audio output.
16 Mobile broadband antenna port two Connect a mobile broadband antenna to increase the range and
strength of the mobile broadband signals.
17 Mobile broadband antenna port one Connect a mobile broadband antenna to increase the range and
strength of the mobile broadband signals.
1 Connections made to these ports must use SELV circuits and the wire (26 AWG-18 AWG) must have Double Insulation (DI) or Reinforced Insulation (RI) to protect it from all
hazardous voltages. Torque the screws at 2.88 kg-cm (2.5 lb-in) to secure the wire to the connector.2 The antenna is shipped in a separate accessory box along with your Edge
Gateway.
VGA connector mapping
Pin
Signal Pin Signal Pin Signal
1 RED 6 GND 11 NC
2 GREEN 7 GND 12 DDCDAT
3 BLUE 8 GND 13 HSYNC
4 NC 9 +5V 14 VSYNS
5 GND 10 GND 15 DDCCLK
Manufacturer part number CCM C070242HR015M408ZR
http://ccm.sg/
NOTE: This part number is for reference only and is
subjected to change.
Features 7