Service Manual

Replacing the top cover

WARNING: Before working inside your Embedded Box PC, read the

safety information that shipped with your Embedded Box PC and

follow the steps in

Before working inside your Embedded Box PC.

After working inside your Embedded Box PC, follow the steps in After

working inside your Embedded Box PC. For more safety best practices,

see the Regulatory Compliance home page at

www.dell.com/

regulatory_compliance.

Procedure

1 Place the top cover into the chassis.

2 Replace the screws that secure the top cover to the chassis.

3 Connect the intrusion-switch cable to the intrusion-switch connector on

the IET board.

Post-requisites

1 Replace the hard drive or solid-state drive.

2 Replace the back cover.