Service Manual

Replacing the I/O plate

WARNING: Before working inside your Embedded Box PC, read the

safety information that shipped with your Embedded Box PC and

follow the steps in

Before working inside your Embedded Box PC.

After working inside your Embedded Box PC, follow the steps in After

working inside your Embedded Box PC. For more safety best practices,

see the Regulatory Compliance home page at

www.dell.com/

regulatory_compliance.

Procedure

1 Replace the power connector and antenna-cable connectors into the

ports.

NOTE: When replacing the antenna-cable connectors into the

ports, ensure that the cable color matches with the color indicated

behind the I/O plate.

2 Align the screw holes on the I/O plate with the screw holes on the

chassis.

3 Replace the screws that secure the I/O plate to the chassis.

4 Replace the hexagonal screws that secure the VGA port, Multi-Function

port, and the COM ports to the I/O plate.

5 Replace the nuts and washers that secure the power connector and

antenna-cable connectors to the I/O plate.

Post-requisites

Replace the back cover.