Service Manual

38
Replacing the access door
WARNING: Before working inside your Edge Gateway, read the safety information that shipped with your Edge Gateway
and follow the steps in Before working inside your Edge Gateway. After working inside your Edge Gateway, follow the
steps in After working inside your Edge Gateway. For more safety best practices, see the Regulatory Compliance home
page at www.dell.com/regulatory_compliance.
Procedure
1. Place the access door in the slot on the left-I/O cover.
2. Tighten the captive screw that secures access door to the left-I/O cover.
Post-requisites
1. Replace the left-I/O cover.
2. Replace the system board.
3. Replace the left-rubber gasket.
4. Replace the status-light lens.
5. Replace the right-rubber gasket.
6. Replace the ZigBee cable.
7. Replace the left-I/O bracket.
8. Replace the right-I/O bracket.
9. Replace the right-I/O cover.
10. Replace the coin-cell battery.
11. Replace the WLAN cable.
12. Replace the antenna-cable bracket.
13. Replace the front cover.
53