Service Manual

Replacing the left-I/O cover

WARNING: Before working inside your Edge Gateway, read the safety information that shipped with your Edge Gateway

and follow the steps in Before working inside your Edge Gateway. After working inside your Edge Gateway, follow the

steps in After working inside your Edge Gateway. For more safety best practices, see the Regulatory Compliance home

page at www.dell.com/regulatory_compliance.

Procedure

1. Insert the tab on the left-I/O cover to the slot on the system base.

2. Slide the left-I/O cover onto the system base at an angle and snap it into place.

3. Replace the dust caps to the left-I/O ports.

Post-requisites

1. Replace the system board.

2. Replace the left-rubber gasket.

3. Replace the status-light lens.

4. Replace the right-rubber gasket.

5. Replace the ZigBee cable.

6. Replace the left-I/O bracket.

7. Replace the right-I/O bracket.

8. Replace the right-I/O cover.

9. Replace the coin-cell battery.

10. Replace the WLAN cable.

11. Replace the antenna-cable bracket.

12. Replace the front cover.