Service Manual

30
Replacing the left-rubber gasket
WARNING: Before working inside your Edge Gateway, read the safety information that shipped with your Edge Gateway
and follow the steps in Before working inside your Edge Gateway. After working inside your Edge Gateway, follow the
steps in After working inside your Edge Gateway. For more safety best practices, see the Regulatory Compliance home
page at www.dell.com/regulatory_compliance.
Procedure
1. Slide the ports on the system board into the slots on the left-rubber gasket.
2. Place the left-rubber gasket on the system board.
3. Slide the left-I/O cover to the system base.
Post-requisites
1. Replace the status-light lens.
2. Replace the left-I/O bracket.
3. Replace the coin-cell battery.
4. Replace the antenna-cable bracket.
5. Replace the front cover.
43