Service Manual

28
Replacing the right-rubber gasket
WARNING: Before working inside your Edge Gateway, read the safety information that shipped with your Edge Gateway
and follow the steps in Before working inside your Edge Gateway. After working inside your Edge Gateway, follow the
steps in After working inside your Edge Gateway. For more safety best practices, see the Regulatory Compliance home
page at www.dell.com/regulatory_compliance.
Procedure
1. Slide the ports on the system board into the slots on the right-rubber gasket.
2. Place the right-rubber gasket on the system board.
Post-requisites
1. Replace the right-I/O bracket.
2. Replace the right-I/O cover.
3. Replace the antenna-cable bracket.
4. Replace the front cover.
40