Service Manual

21
Removing the ZigBee cable
WARNING: Before working inside your Edge Gateway, read the safety information that shipped with your Edge Gateway
and follow the steps in Before working inside your Edge Gateway. After working inside your Edge Gateway, follow the
steps in After working inside your Edge Gateway. For more safety best practices, see the Regulatory Compliance home
page at www.dell.com/regulatory_compliance.
Prerequisites
NOTE: Depending on the conguration ordered, the ZigBee antenna and cable may not be available.
1. Remove the front cover.
2. Remove the antenna-cable bracket.
3. Remove the right-I/O cover.
4. Remove the right-I/O bracket.
Procedure
Remove the ZigBee cable from the system board.
32