Service Manual

20
Replacing the right-I/O bracket
WARNING: Before working inside your Edge Gateway, read the safety information that shipped with your Edge Gateway
and follow the steps in Before working inside your Edge Gateway. After working inside your Edge Gateway, follow the
steps in After working inside your Edge Gateway. For more safety best practices, see the Regulatory Compliance home
page at www.dell.com/regulatory_compliance.
Procedure
1. Place the right-I/O bracket on the system board.
2. Align the tabs on the right-I/O bracket to the system board and snap the right I/O bracket into place.
3. Replace the screw (M3x10) that secures the right-I/O bracket to the system board.
Post-requisites
1. Replace the right-I/O cover.
2. Replace the antenna-cable bracket.
3. Replace the front cover.
31